It was evening, there was nothing.
I bought the light bulbs ( I do not remember which, I repent, but I took it from bulbs from this site )
Narva 17097 Incandescent lamp (3W) — 4 pieces.
Narva 17037 Incandescent lamp (1,2W) — 6 pcs.
Three bottles of beer and a friend are morally helpful.
We unscrew the five screws that hold the bottom panel.
Begin to remove the panel from the right near the ignition switch. There is no self-tapping, in this upper corner the panel is held on the latch. We pull the panel strongly, but very carefully, especially for those who have a temperature sensor there.
After the fasteners are unscrewed, we podderaem device from the top between the device and the visor is something flat. I did it with a thin flat screwdriver and pull myself.
Carefully pull out the instrument panel (somewhere on the Internet there is infa, that the device can not be tilted, twirl, etc., so that some gel does not flow out (sealant?)), But I did not think about it.
We hold the pribrku in our hands, and see the socle of the bulbs.
Pull the light bulb hands did not work. Twisted and twisted and so and so, I thought I should somehow get this thing out properly, but I never thought of how, so I took the pliers, and carefully, counterclockwise twisted it 45 degrees approximately, after which the cap and lamp were pulled out.
I did it in turn. He unscrewed one, replaced the bulb in the plinth, screwed it in the reverse order. Passed to the next.
Bought lamps were all (4 large, 6 small), but one small flew into the world of pro things directly from the sealed bag, which were tremblingly placed by the seller in the store. And since the replacement procedure was conducted from 23:00 to 1:00, then there was nowhere to buy, then changed only 5 of the 6 small ones.
Форд Мондео 3: Снимаем панель управления
we put the device into place, fasten it to the seats, everything in reverse order, until we reach the bottom panel to which the temperature sensor is attached.
It is attached by two screws. I twisted it to clean it, and I was confused that it loosely hangs loose in the case, which is screwed to the panel. On the sensor itself there is a rubber band, and a corner (see the photo below), as if he is screwed somewhere to a click. I have the corps palamaty myself, although I did not see visible damage, or the hell knows what …
In general, there was no time to search in the phone for information on how it should be and what’s wrong with it, blew the sensor as I could (it turned out pretty well), screwed it into place on the panel, screwed the panel itself with the remaining five screws and … turned on the dimensions, admired uniform green illumination of the instrument panel.
This procedure of replacing the bulbs in the instrument was completed, all thanks for attention, maybe someone will someday come in handy this report.